In 2007, a Jeep Compass was equipped with a transmission control module (TCM) that helped to control the vehicle’s transmission. The TCM was located in the engine compartment, near the battery. If the Jeep Compass ever had a problem with the transmission, the TCM would be the first place to check.
Where Is The 2007 Jeep Compass Transmission Control Module Located?
2007 Jeep Compass Transmission Control Module Location
The 2007 Jeep Compass Transmission Control Module is located in the engine compartment, on the drivers side, just below the starter. It is a black box, about 4 inches square. There are 2 wires going to it, one is black with a white stripe, and the other is red with a white stripe.
If your Jeep Compass is having transmission problems, the first thing you should check is the Transmission Control Module. This is a common problem on Jeeps and is often the cause of transmission issues.
How Do I Access The 2007 Jeep Compass Transmission Control Module?
Jeep Compass owners who need to access the transmission control module will be happy to know that it is a relatively easy process. Here are the steps to follow:
1. Open the hood of your Jeep Compass and locate the battery.
2. Disconnect the negative terminal from the battery.
3. Locate the transmission control module. It will be on the driver’s side of the vehicle, near the firewall.
4. Unscrew the bolts that secure the transmission control module to the vehicle.
5. Pull the transmission control module out of its housing.
6. Reconnect the negative terminal to the battery.
7. Start your Jeep Compass and test the transmission control module to make sure it is working properly.
If you are having trouble finding the transmission control module, consult your Jeep Compass owner’s manual. It should have a diagram that will show you exactly where it is located.
What Are The Symptoms Of A Bad 2007 Jeep Compass Transmission Control Module?
A bad 2007 jeep compass transmission control module can cause a variety of symptoms. The most common symptom is the transmission slipping or not engaging properly. Other symptoms can include the transmission shifting erratically, the transmission not shifting at all, or the transmission shifting into the wrong gear. If you are experiencing any of these symptoms, it is important to have your Jeep checked by a qualified mechanic as soon as possible.
How Do I Troubleshoot A 2007 Jeep Compass Transmission Control Module?
If your 2007 Jeep Compass is having transmission problems, the first step is to check the transmission control module. The transmission control module is a computer that controls the transmission. If the transmission control module is not working properly, it can cause the transmission to shift improperly or not shift at all.
There are a few things you can do to troubleshoot the transmission control module. First, check the fuse. The fuse for the transmission control module is located in the fuse box under the hood. If the fuse is blown, replace it with a new fuse.
Next, check the wiring harness for the transmission control module. The wiring harness connects the transmission control module to the transmission. If the wiring harness is damaged, it could cause the transmission control module to malfunction.
Finally, check the transmission control module itself. If the transmission control module is damaged, it will need to be replaced.
If you are still having problems with the transmission after troubleshooting the transmission control module, it is likely that the problem is with the transmission itself.
How Do I Replace A 2007 Jeep Compass Transmission Control Module?
1. Park your Jeep Compass and set the parking brake.
2. Disconnect the negative battery cable using a wrench to loosen the nut.
3. Locate the transmission control module (TCM) under the hood on the driver’s side near the firewall.
4. Unplug the electrical connector from the TCM.
5. Remove the two bolts holding the TCM in place using a wrench.
6. Install the new TCM in the same location and torque the bolts to 18 ft-lbs.
7. Plug in the electrical connector.
8. Reconnect the negative battery cable.
9. Start the Jeep Compass and check for proper operation.
If you have any questions or concerns, consult a professional mechanic for assistance.
Conclusion
The 2007 Jeep Compass transmission control module (TCM) is located in the engine compartment, on the passenger side near the firewall.
Hopefully, you are clear on the location of the 2007 jeep compass transmission control module. If you still have any questions, feel free to comment below.
Author
-
by
-
